boom audio installation instructions harley

Of course, this assumes you're running a Stage I system where a single amp supplies 75watts/channel to each of the 4 speakers. While it might seem theoreically 'wasteful' to not be able to utilize those 100 watts, I'd speculate that it's not enough wattage to properly power the LF speakers.Īs you've removed your TourPak and have no interest in rear speakers, as OBB suggested, you theoretically should be able to (creatively?) connect your LF speakers to the TourPak speaker cabling with all 4 speakers powered by your existng front fairing amp. The BOOM! BOX 6.5GT Radio itself has a built-in internal amp rated at 25watts/channel for the basic (lower quality) 4 channel audio system, but as OBB said, it apparently 'doesn't power any speakers' (when the optional 300 watt amp is connected). I want to add these speakers to my FLHTKSE and as the fitting instructions say:.

Quote from: ptnlinda on April 01, 2017, 03:47:28 AM This certainly is confusing. You just instal with accessory wiring harness's then get Boom reflashed by dealer. No where does it say we need to add an extra amplifier when installing these on a FLHTKSE. Have a Harley-Davidson dealer update the radio EQ using Digital Technician II.' After installing seat, pull up on the seat to verify that it is secure. Install the ECM caddy per the service manual.

(00068a)Īpply a light coat of petroleum jelly or corrosion retardant material to battery terminals. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. To prevent possible damage to the sound system, verify that the ignition switch is OFF before attaching the battery cables.Ĭonnect positive (+) battery cable first. Unless previously installed, connect vehicle connector (4-way pin side Molex under seat) to 296 (4-way socket side) of speaker expansion kit.Īll models except 2015 and later FLHXSE: Proceed to the COMPLETION Section of this document. Connect pin side of 69200489 jumper to wire harness from this kit (10). 'CVO Ultra and Trike: Insert 6920714 (unless already in place) into connector behind passenger seat.Ĭonnect socket side 4-way to speaker expansion harness audio and 4-way pin side to socket side of 69200489 jumper.

Boom audio installation instructions harley